断路器合闸电阻热容量及额定参数计算分析 

黄然，赵现平，雷圆圆，张恭源 
云南电力试验研究院(集团)有限公司电力研究院，云南 昆明 650217 
 

摘 要：合闸电阻热容量、阻值和接入时间是反映其可靠性的最直接参量。以实际参数的500kV输电系统为计算对象，考虑多种系统工况，对断路器合闸操作时合闸电阻获得结构热进行计算分析，给出500kV断路器合闸电阻热容量的合理范围，并对电阻值和接入时间对操作过电压的影响作定性定量分析。
关键词：合闸电阻；热容量；接入时间；操作过电压；空载合闸
中图分类号：TM561 文献标识码：A 文章编号：1007-3175(2013)08-0022-03

Calculation Analysis on Thermal Capacity and Rated Parameters of Circuit-Breaker Closing Resistors 

HUANG Ran, ZHAO Xian-ping, LEI Yuan-yuan, ZHANG Gong-yuan 
Electric Power Research Institute, Yunnan Electric Power Test & Research Institute Group Co., Ltd, Kunming 650217, China 
 

Abstract: Thermal capacity, resistance value and current-carrying time are the most direct parameters to reflect the reliability of circuit-breaker closing resistors. Based on 500 kV AC transmission system simulation model with actual parameters, closing resistor thermal capacity under different operation conditions was calculated and reasonable value range of 500 kV AC transmission system was put forward. At last the quantitative analysis was made to the impacts of resistance value and current-carrying time on switching overvoltage.
Key words: closing resistor; thermal capacity; current-carrying time; switching overvoltage; no-load closing

参考文献
[1] DL/T405—1996 进口252(245)～550kV交流高压断路器和隔离开关技术规范[S].
[2] GB/Z24838—2009 1100kV高压交流断路器技术规范[S].
[3] 徐鹏，林宝玉，刘玮，张鑫，雷丰瑞.基于ATP-EMTP对500kV输电线路取消合闸电阻的仿真研究[J].电瓷避雷器，2011(6)：70-75.
[4] 王剑，朱芸.500kV输电线路断路器合闸电阻配置原则[J].电力系统自动化，2008，32(19)：100-103.
[5] 计荣荣，易强，苏菲，孙可，陈稼苗，周浩.超/特高压交流输电线路断路器合闸电阻的适用性研究[J].电网技术，2011，35(1)：18-25.
[6] 浦仕遵，姜虹云，赵现平.500kV断路器合闸电阻检查方法[J].云南电力技术，2011，39(6)：98-99.